Export-Settings

If bend lines stopped appearing in your DXF exports after a SolidWorks service pack update, you are not alone. The r/SolidWorks threads from August 2026 show multiple engineers hitting this after 2025 SP5 and 2026 SP3. Some had working configurations for years. They installed the update, exported a flat pattern, and the bend lines were gone. The problem is fixable — but only if you understand that bend lines disappear for fundamentally different reasons depending on how you export. Applying the wrong fix wastes time and leaves you thinking the issue is deeper than it is. ...

Two posts in the last week on r/SolidWorks surface the same class of bug: DXFs that look fine in SolidWorks land corrupted downstream. One user watched bend lines lean off-axis on a small flange until they dropped the end point merging tolerance from 1 to 0.1. Another spent a week re-ticking the entity checkboxes on every export because SolidWorks does not remember them. Both problems come from defaults that SolidWorks ships and almost nobody documents — buried in a bitmask you only see if you touch the API. ...

If you’ve spent any time in SolidWorks sheet metal forums, you’ve seen the same conversation play out: someone asks how everyone handles tabs and slots, and the replies split into three camps — Design Library features, manual boss extrudes, and the built-in Tab and Slot feature. Each approach works, but they all share one frustrating problem when it comes time to export DXFs. You forget a setting, and your fabricator gets bad files. ...